Reads PIV II End Point and PIV II Transitional cards including FRAC (SmartMX), DoD alpha & beta, DESFire PIV (V0.6 only), TWIC V1, MMAC, DESFire SN (1st 4bytes), and MIFARE SN. High-intensity display version of DS47L-SSDM-IE.ĭS47L ScramblePad with embedded 13.56MHz, ISO 14443-4 A&B contactless smart card reader and antenna. Installs in Hirsch mounting boxes (MB2 or deeper). Reads DESFire file system and MIFARE sector cards. High-intensity display version of DS47L-SSP-HID-SN.ĭS47L ScramblePad with embedded 13.56MHz, ISO 14443-4A contactless smart card reader and antenna. Use MIFARE, DESFire, iCLASS, or HID 125kHZ cards. Same as DS47L-SSP-HID but reads MIFARE/DESFire serial numbers, iCLASS, and HID 125kHz proximity. High-intensity display version of DS47L-SSP-HID. Use PIV II, DESFire with FASC-N encoding, iCLASS cards., or HID 125kHZ cards. Reads PIV II End Point, DESFire (with CHUID only), iCLASS, and HID 125kHz proximity. High-intensity display version of DS47L-SS-HID-SN.ĭS47L ScramblePad with embedded 125kHz proximity and 13.56MHz, ISO 14443A&B contactless smart card readers and antennae. Same as DS47L-SS-HID but reads MIFARE/DESFire Serial Numbers, and iCLASS. High-intensity display version of DS47L-SS-HID. Use PIV II, DESFire with FASC-N encoding, or iCLASS cards.
Reads PIV II End Point, DESFire (with CHUID only), and iCLASS. High-intensity display version of the ScrambleSmart with integrated MIFARE DESfire smart card reader.ĭS47L ScramblePad with embedded 13.56MHz, ISO 14443-4 A&B contactless smart card reader and antenna. Same as ScrambleSmart but with integrated MIFARE DESfire smart card reader. High-intensity display version of ScrambleSmart. ScrambleSmart which incorporates a ScramblePad with an integrated MIFARE smart card reader. High-intensity version of the DS47L-SPX ScrambleProx with built-in Indala reader. Use HID cards.ĭS47L-SPX ScrambleProx with built-in Indala reader. High-intensity version of the DS47L-SPX ScrambleProx. All-in-one ScramblePad/MATCH reader interface with built-in HID proximity reader. Table 1-11 shows the many types of ScramblePads that are availableĬombines the ScramblePad with a MATCH reader interface. If it’s not right, the ScramblePad will be difficult to use properly. Pay special attention to the specified mounting height for the ScramblePad. Make sure you select the correct ScramblePad mounting box for the applications and conditions specific to each door. Pull cable runs from the controller to ScramblePads for each door. Trigger relays for equipment or process control This section includes design notes on the following devices: Remote Output Component's section includes design notes on the following devices: Remote Input Component's section includes design notes on the following devices:
0 kommentar(er)
